Network

This page contains two tabs, one displays the network settings of the high-availability cluster and the other the hosts. You can get an overview of the network interface usage and create or remove additional cluster connections if necessary.

HA Cluster

General

The hostname of the cluster is shown here. Note that the hostname must be different from either of the two hosts.

Network

All network connections, regardless used or un-used, are displayed in this field. At least one of the cluster interfaces is displayed here. Additional interfaces can be manually added by clicking the Manage Network Interface button. The Heartbeat interface listed is the only Heartbeat connection allowed in the cluster.

The grid shows the below information:

To configure network interface settings:

You can manually configure the IP address and subnet mask of both servers in a cluster. Click the Manage Network Interface button to edit network interface settings.

  1. Go to Server Network Information and click Configure Server Network.
  2. Choose Use manual configuration and manually enter the following information for each or either server:
  3. Click OK to continue.
  4. Click Apply to save the new settings.

Note:

Hosts

This tab shows the status and information of network interfaces on the active and the passive server: